1 / 1
2 inch props for whoop / toothpick
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An experimental design of 2" props for a tiny drone. Needs a bit of post-print sanding of rough edges
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 51
- Makes
- 1
- Views
- 147
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
I have tried printing these in ASA, they do fly quite OK, but not as efficient as factory made props (i.e. battery is not lasting for as long as on factory made prop)
Also printed in ASA they are very brittle - I was flying an open prop toothpick, any slight crash result in prop exploding. So only use these if you are desperate :-) (On the other hand - you can print as many as you like, they are cheaper than factory made props)