1 / 3
Chicken Red Mite Trap | Milbenfalle | Milbensperre — image 1
1 / 3

Chicken Red Mite Trap | Milbenfalle | Milbensperre

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Two part mite trap for the chicken coop. To prevent mite infestation.

Rating
0 / 5
Likes
6
Downloads
28
Makes
0
Views
201
Reviews
0

Updated at source:

Model information

Category
Pets
License
Creative Commons — Attribution — Noncommercial

Milbensperre für den Hühnerstall in zweiteiliger Ausführung. Das Bauteil "Flansch_Huhnerstange_Milbensperre_V3" kann auch ohne das Unterteil verwendet werden, sollte eine Erhöhung nicht benötigt werden. 

Gedruckt wurde die Milbensperre mit folgenden Parametern:

Material: ABS (Alternativ auch ASA, PETG oder TPU möglich, jedoch nicht getestet)

Schichthöhe: 0,20 mm 

Wanddicke: 3 Schleifen / 1,2 mm

Boden- und Deckendicke: 5 Schichten / 1,00 mm

Infill: Gyroid / Kubisch oder ähnlich 10 - 20 % nach belieben.

Stützen: Nur Aussparung - siehe Bild


Mite barrier for a chicken coop in a two-part design. The component “Flansch_Huhnerstange_Milbensperre_V3” can also be used without the lower part if an elevation is not required.

The mite barrier was printed using the following parameters:

Material: ABS (ASA, PETG, or TPU are also possible alternatives, but have not been tested)

Layer height: 0.20 mm

Wall thickness: 3 perimeters / 1.2 mm

Top and bottom thickness: 5 layers / 1.00 mm

Infill: Gyroid / cubic or similar, 10–20% as desired

Supports: Only for the recess – see image

Tags