1 / 3
Chicken Red Mite Trap | Milbenfalle | Milbensperre — zdjęcie 1
1 / 3

Chicken Red Mite Trap | Milbenfalle | Milbensperre

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Two part mite trap for the chicken coop. To prevent mite infestation.

Ocena
0 / 5
Polubienia
6
Pobrania
28
Wydruki
0
Wyświetlenia
196
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Pets
Licencja
Creative Commons — Attribution — Noncommercial

Milbensperre für den Hühnerstall in zweiteiliger Ausführung. Das Bauteil "Flansch_Huhnerstange_Milbensperre_V3" kann auch ohne das Unterteil verwendet werden, sollte eine Erhöhung nicht benötigt werden. 

Gedruckt wurde die Milbensperre mit folgenden Parametern:

Material: ABS (Alternativ auch ASA, PETG oder TPU möglich, jedoch nicht getestet)

Schichthöhe: 0,20 mm 

Wanddicke: 3 Schleifen / 1,2 mm

Boden- und Deckendicke: 5 Schichten / 1,00 mm

Infill: Gyroid / Kubisch oder ähnlich 10 - 20 % nach belieben.

Stützen: Nur Aussparung - siehe Bild


Mite barrier for a chicken coop in a two-part design. The component “Flansch_Huhnerstange_Milbensperre_V3” can also be used without the lower part if an elevation is not required.

The mite barrier was printed using the following parameters:

Material: ABS (ASA, PETG, or TPU are also possible alternatives, but have not been tested)

Layer height: 0.20 mm

Wall thickness: 3 perimeters / 1.2 mm

Top and bottom thickness: 5 layers / 1.00 mm

Infill: Gyroid / cubic or similar, 10–20% as desired

Supports: Only for the recess – see image

Tagi