Swappable Stamp Storage Tubes (fusion360)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Storage tubes for the swappable stamp and its inserts
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 38
- Makes
- 0
- Views
- 126
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
Since I made quite a few insert packs (groups of inserts in a publication) for my swappable stamp design, I wanted a better way to store them and keep the packs separated from each other, so I made these tubes.
The larger tube is for the base kit: the stamp and its 6 base inserts and the others are for all the other insert-only packs. The fusion file allows you to easily change the size to fit any insert amount, would you need it, as they vary from pack to pack.
Printing information:
Split each tube model to its parts before printing each part separately
Print both parts of the tube on their flat surface (bottom for main body and top for the cap)
I recommend printing each part one after another and not at the same time, even if it's slightly slower. Otherwise, you might get a visible difference below and above on the main body when the cap finishes printing.
No supports nor brim are needed
As the inserts can have ink or water on them, I recommend printing these tubes out of PETG instead of PLA, as the latter is porous, so more prone to moisture and bacterial buildup.
Please refer to the base model for more information.
---
Erratum (13/01/26): Addition of the 24-inserts storage tube