Klicky Probe mount for the Delta Flyer printer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount for the regular Klicky Probe to the Delta Flyer carriage
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 16
- Makes
- 0
- Views
- 155
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- GNU General Public License v3.0
Mount for the regular Klicky Probe to the Delta Flyer carriage. There is no dock (yet?) so it will have to be attached manually before any probing is done. Very useful for doing the delta_calibrate for example, but you can also do a bed mesh and store it.
Hardware:
Mounts to the front of the carriage, using 2 M3x6 BHCS into the existing holes. Careful, taps into plastic.
Lead the wires through the umbilical to the electronics. The DF1 connector is a 3-pin JST, the bottom 2 pins are GND and Signal.
Configuration:
Don't use the Klicky macros, since we do not have a dock. Just this is enough:
[probe]
pin: ^h616:gpio203 //DET1 port, PG11
x_offset: 0
y_offset: -14.4
z_offset: 1.7
speed: 5.0
samples: 2
sample_retract_dist: 2.0
samples_tolerance_retries: 3[bed_mesh]
speed: 100
horizontal_move_z: 4
mesh_radius: 45 // Can't go much larger because of the offset
mesh_origin: 0,0
round_probe_count: 5
algorithm: bicubic
zero_reference_position: 0,0
If the probe is not attached during probing, the printer will throw an error: Probe triggered prior to movement