1 / 4
Extruder Cover for Flsun QQ-S Pro — image 1
1 / 4

Extruder Cover for Flsun QQ-S Pro

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a modified version of TownDrunk's 'Extruder cover for FLSUN delta'.

Rating
0 / 5
Likes
2
Downloads
9
Makes
0
Views
50
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Share Alike

I haven't figured out how to get my printer to not try long bridges, and it does a horrible job (with these two models) at trying to add supports to the floating bits, so I added some slabs and sank them down to just about a layer's width of gap below the floating bits. Turned out pretty nice and was not too bad to remove. It did, however, leave behind just a bit of white marks from when I separated the pieces.

I printed the main object with 0.2mm layers and 15% infill. I changed the infill of the slabs to 5% and left them with 2 solid layers top and bottom. One iteration I selected 1 layer each and it was a bit more messy to remove.

As this is a decorative piece, you could probably get away with some 2 solid layers and 2 or so perimeters. I just know someone in my house is going to put something on it at some point and it'll snap. So I went for 3 solid layers top and bottom and 3 perimeters.

Printed with Amolen Red Apple PLA.

It mounts with M3 screws. They'll thread themselves into the holes. I'll probably add some washers and nuts later... because I have them.

Tags