Extruder Cover for Flsun QQ-S Pro
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a modified version of TownDrunk's 'Extruder cover for FLSUN delta'.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 50
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
I haven't figured out how to get my printer to not try long bridges, and it does a horrible job (with these two models) at trying to add supports to the floating bits, so I added some slabs and sank them down to just about a layer's width of gap below the floating bits. Turned out pretty nice and was not too bad to remove. It did, however, leave behind just a bit of white marks from when I separated the pieces.
I printed the main object with 0.2mm layers and 15% infill. I changed the infill of the slabs to 5% and left them with 2 solid layers top and bottom. One iteration I selected 1 layer each and it was a bit more messy to remove.
As this is a decorative piece, you could probably get away with some 2 solid layers and 2 or so perimeters. I just know someone in my house is going to put something on it at some point and it'll snap. So I went for 3 solid layers top and bottom and 3 perimeters.
Printed with Amolen Red Apple PLA.
It mounts with M3 screws. They'll thread themselves into the holes. I'll probably add some washers and nuts later... because I have them.