Orbiter v2 EBB36 45 degree umbilical mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Allows you to mount the EBB36 at a 45 degree angle to allow more room on the Z-axis
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 14
- Makes
- 0
- Views
- 134
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
After converting my Switchwire (VS.643) to Dragonburner, I was disappointed to lose quite a lot of vertical build volume. This was due to an umbilical adapter for the EBB36 Gen 2 that mounts the CAN cable at a 90 degree (vertical) angle. This also puts added strain on the cable and requires a larger umbilical loop. It seemed to me that mounting the cable at 45 degrees, angled toward the base end, would require less cable, less vertical space, adn reduce strain.
I printed mine in PETG with 15% infill.
Install M3 x 0.5 x 4.0 brass inserts into the larger mount holes for the EBB36. Attach the part to the standoffs on the Ortbiter v2 extruder using M3 screws. Attach the EBB36 to the part. I installed mine without removing any connections to the board (but with the toolhead out of the printer).
Use a couple zip ties to secure the CAN connector.