250mm Marble-Bearing Lazy Susan (Smooth, Low-Profile, Printable Turntable)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
250mm low-profile Lazy Susan using 14mm marbles instead of bearings. Optional rim included.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 16
- Makes
- 0
- Views
- 130
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
This is a 250 mm (≈10") low-profile Lazy Susan that uses standard 14 mm marbles as the bearing surface for smooth, quiet rotation — no specialty bearing rings required.
The design captures 45 marbles between printed races to distribute load evenly and provide stable, fluid motion. Glass marbles are recommended because they’re inexpensive, easy to find, and more than sufficient for this application.
An optional rim can be added to keep items contained, making it ideal for seasonings, condiments, or tabletop organizers. Leave the rim off for a flat, unobstructed surface, perfect for cake decorating or display use.
The exploded and cross-section views illustrate:
Blue → printed parts
Transparent cyan → marbles
Gray → screws & washer
Orange → heat-set insert
Yellow → assembly/alignment lines
🧩 Features
✔ Uses inexpensive 14 mm marbles (glass recommended)
✔ Optional rim for containment or spill prevention
✔ Smooth rotation with wide load distribution
✔ Minimal hardware
✔ Forgiving tolerances — works well across printers
✔ Minimal Supports — just one spot on one part.
📐 Specifications
Overall diameter: 250 mm
Plate height: ~30 mm
Rim height (optional): ~25+ mm additional
Bearing type: Captured loose marbles
Marble count: 45
Marble size: 14 mm diameter
🧰 Hardware Required
With Rim Installed
45 × 14 mm marbles (glass recommended; any material works if size is correct)
7 × M3 screws
Length: 10–25 mm (use what you have)
1 × M3 washer
1 × M3 heat-set insert
Without Rim (Flat Plate Only)
45 × 14 mm marbles
1 × M3 screw (10–25 mm)
1 × M3 washer
1 × M3 heat-set insert
🖨 Printing Recommendations
Material: Anything Rigid (PLA, PETG, ABS, etc.)
Layer height: 0.2 mm recommended
Infill: 15–25%
Perimeters: 3+
Supports:
A small amount of support is needed under the inner flat of the recessed screw hole of the plate part.
This keeps the screw head flush so the top surface remains smooth and uninterrupted
Supports are minimal and easy to remove.
🔧 Assembly Overview
Install the heat-set insert (location shown in orange)
Place 45 marbles evenly into the bearing channel
Align plate and base
Secure with the required number of screws (1 without rim, 7 with rim)
Adjust screw tension slightly to fine-tune rotation
Avoid overtightening — the marbles should roll freely.
⚠ Notes
Glass marbles are ideal: cheap, smooth, and readily available
Metal ball bearings: relatively inexpensive and smooth, but heavy.
Printed marbles can work but will roll rough and are not recommended
Any marble material is acceptable as long as the diameter is 14 mm, the surface is smooth, and the material is relatively durable.