Gridfinity Alex drawer tray grid (economic variant)
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.07 – €0.09 net (excluding VAT)
For file: Alex Drawer Tray - Connector (bigger holes)_0.4n_0.2mm_PLA_COREONE_5m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.08 excluding VAT (range midpoint).
- Weight reported by the author
- 1 g
- Print time reported by the author
- 4.8 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Tray that makes it easy to remove bins on the front of an Alex drawer, so you can slide and access the ones on the back!
- Rating
- 5 / 5
- Likes
- 40
- Downloads
- 137
- Makes
- 1
- Views
- 1,970
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
Since the Alex drawers do not open fully, it is hard to reach the bins on the back of the drawers.
This tray allows you to quickly remove bins on the front of the drawer, making it possible to slide the ones on the back to access them!
There are other designs for this around the internet, but I've found them to require too much material and time for this purpose. This one was designed to be simple and economical, not requiring much more material than usual gridfinity magnet grids.
Just print two of the tray parts (its the same part for both sides), print four connectors and glue them. You can also insert filament into the connectors for extra strength, but if the glue is good it probably isn't needed.