Powercon passthrough to IEC13 "computer plug" with PG7 strain relief
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This little adapter allows you to keep your stage listing cables tidy
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 29
- Makes
- 0
- Views
- 154
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Print this with the threaded side down. I used PETG with no supports nor brim at .20mm layer height on a modified Ender 3, but just about anything will do.
For hardware I used some inexpensive Powercon D-style panel mounts and a waterproof PG7 cable gland for strain relief, and 3x12mm black screws.
Internally, I used 12 gauge wire to ensure that the Y could pass the full 20A allowed by the power con, but then I just cut the end of an inexpensive 18 gauge IEC13 cord I had lying around. I used direct soldering to the powercon tabs and tucked it all inside.