Nixie Lamp

💎 Features

1. Includes files for popular E26/27 pendant light fixtures: threaded and smooth-walled fixtures.

2. The single wall lamp shade utilizes “spiral vase” mode to optimize print times.

3. The shade easily snaps into place and can be twisted off the base to change the bulb.

4. All parts are 3d printed, with the exception of the light hardware noted below. The base optionally includes 4 TPU feet to protect your surfaces.

🔨 Parts & Files

• Includes 3MF + STL files and PDF print instructions.

• Easy to slice using PrusaSlicer, OrcaSlicer, or Bambu Studio.

• Requires a minimum bed size of 160mm x 160mm x 216mm.

• 1x 5-9 watt 26/E27 LED Bulb (Low wattage), 2.5” (6.3cm) max diameter

• 1x E26/E27 Pendant light fixture

  • Variant 1: Threaded (40mm OD),  Pendant Light Cord Lamp Kit - Amazon.com

  • Variant 2: Smooth-walled (37mm OD), JACKYLED 12ft pendant light - Amazon.com

📊 Print Statistics (Prusa Core One, 0.6mm nozzle)

• Shade - PETG exterior: 82g, 1.6hrs

• Shade - woven interior: 70g, 4.2hrs

• Base: 97g, 3.2hrs (including parts)

📖 Instructions

I recommend reviewing the PDF for printing and assembly instructions. Here are the highlights:

1. Printing

   1. The shade is printed in two parts, both with "spiral vase" mode and 0% infill.

   2. Disable dynamic speeds for the PETG shade to keep the surface texture uniform. Lower speeds will produce more transparent results.

   3. Print the base with your preferred settings. No special profiles required.

2. Assembly - smooth-walled fixture

   1. Insert the fixture from below until the top is approximately 2 mm above the base. Twist on the printed threaded collar to secure the fixture.

   2. Insert the fixture cord into the slot at the bottom of the base. Secure it in place with the printed plug.

3. Assembly - threaded fixture

   1. Insert the fixture from below and thread on the fixture ring until it's secured.

   2. Insert the fixture cord into the slot at the bottom of the base. Secure it in place with the printed plug.

4. Assembly - shade

   1. First, thread in the LED bulb.

   2. Insert the woven shade above the bulb and twist the shade until you feel a gentle snap.

   3. Insert the PETG shade above the woven shade. You may need to wiggle the shade around the woven shade. Like before, twist it until you feel a gentle snap.

** These files are for personal use only and not to be resold