Fidget Spinner YAFS
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
For a long time I was looking for a spinner where the bearings are touching. It makes it smaller in diameter and much easier to handle for people with smaller hands. It turns out to be a nightmare to design, which is probably why I haven't seen any online. Finally I got the geometry just right. All bearings sit tight, are touching, and even snug around the edges of the bearings. As a result, it also became the thinnest spinner I've seen so far, with 608 bearings at least.
Hope someone enjoys this. I had to go though some filament to find the right fit. Check out the pictures.
Happy printing!
Print instructions
PETG for stability but use whatever you prefer
Start with standard settings of 0.15 mm (speed)
The rest as you like. I used Honeycomb infill with 25% and 2 perimeter
Remember to print 8 caps
License
You must give appropriate credit
If you remix you must distribute under the same license: Creative Commons — Attribution — Share Alike