Prusa Core ONE / + storage bottom tray for model @prusaguy
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
bottom box, using the bottom part of the model, without a magnet, held with tape or glue.
- Rating
- 5 / 5
- Likes
- 26
- Downloads
- 100
- Makes
- 3
- Views
- 959
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Print PetG Prusament Galaxy Black
Prusament PETG Prusa Galaxy Black 1kg | 3D tiskárny Original Prusa přímo od Josefa Průši
This prusament fits perfectly with the printer frame
Print:
0.4n
0,2mm structural
3 perimeters
I tested various options for attaching the model without interfering with the original already printed model while maintaining the simplicity of printing. Magnets were tested and I was not satisfied with the results for universal reproducibility.
Finally I chose the universal tolerance of the model and 3M adhesive tape 1mm
Here is the installation procedure:
stick double-sided acrylic foam tape with a red polyethylene liner
leave a little bit of the left edge of the model
2.
remove the protective red tape and attach the model, see photo
3.
Press the model into place.
I recommend trying this method without the tape.
The model has sufficient tolerance, I used 1.1mm tape. The model must not extend beyond the edge of the box frame
When pushing the model to the back without tape, the tolerance in the front is 2mm. The side and bottom tolerances are 0.6mm.
