40 mm to 80 mm motherboard fan adapter for Qidi Q2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adapter for replacing the noisy 40 mm motherboard fan with a quieter and more efficient 80mm one.
- Rating
- 5 / 5
- Likes
- 42
- Downloads
- 174
- Makes
- 4
- Views
- 1,154
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Adapter for replacing the noisy 40 mm motherboard fan with a quieter and more efficient 80mm one. Significantly reduces printer noise (especially during idle).
Filament:
PETG or more heat-resistant (ASA, ABS...)
Printing Parameters:
Layer Height: 0.16 mm
Number of Perimeters/Walls: 5
Required equipment/hardware:
x1 - 80mm fan, 24V.
x8 - M3 screws, 10-12 mm long.
Installation Sequence:
Remove the rear panel.
Disconnect the 40 mm fan from the motherboard.
Remove the 40 mm fan.
Install the adapter in its place.
Mount the 80 mm fan onto the adapter.
Connect the 80 mm fan to the motherboard. (My fan had a 3-pin connector. I cut it off and soldered on the connector from the removed fan).
Reinstall the rear panel.
Additional Notes:
For further noise reduction, you can lower the fan speed. To do this, in the printer.cfg file, in the [controller_fan board_fan] section, set the fan_speed parameter to a value between 0.5 and 1.0.
