Jet-lift air collar for Matten filter uplift tubes
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Serviceable jet-lift air collar for Matten filter uplift tubes. Fits metric and US PVC. Tool-free cleaning.
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 175
- Makes
- 0
- Views
- 668
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This jet-lift air collar implements well-established air-lift / jet-lift principles commonly used in Matten and sponge filtration systems, adapted specifically for 3D printing and home use.
The design consists of two interlocking parts, allowing controlled air injection into the uplift tube to improve lift efficiency compared with simple open air stones or drilled pipe methods.
A length of pvc pipe and a 90 degree PVC swept bend are needed to complete the item.
Key advantage: serviceable design
Unlike many one-piece or permanently bonded jet-lifts, this collar comes apart for cleaning.
In long-term aquarium use, uplift injectors inevitably accumulate:
biofilm
fine debris
bacterial slime
With fixed or glued designs this buildup is difficult to remove and gradually degrades performance.
This design can be fully disassembled, rinsed, and reassembled in seconds, restoring performance without tools or solvents.
Included sizes
Metric: 20 mm, 25 mm PVC
Imperial (US): ½″, ¾″, 1″ Schedule 40 PVC
Imperial models are based on actual pipe outside diameters, not nominal inch sizes.
Fit and tolerances
Designed with 0.2 mm diameter clearance for a firm push-fit
Best used on clean, deburred pipe ends
If the fit is tight, lightly chamfer the pipe or scale the model to 100.5–101%
Printing
No supports required
Print orientation as supplied
PLA, PETG, or ABS
0.2 mm layer height works well
Parametric model
A fully parametric Onshape model is linked for users who want to:
adjust pipe sizes
change tolerances
modify the geometry