1 / 3
4 in. x 1-1/2 in. Spigot Hub Flush Bushing for PVC DWV — image 1
1 / 3

4 in. x 1-1/2 in. Spigot Hub Flush Bushing for PVC DWV

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Bushing goes inside 4" DWV pipe, then 1-1/2" pipe is inserted into the bushing. Not glued.

Rating
0 / 5
Likes
1
Downloads
9
Makes
0
Views
64
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution

This bushing allows the insertion of the 1-1/2 pipe into the 4" pipe. The connection is intentionally not glued so that if the 4" in-ground pipe shifts or freezes, the drain waste pipe connection can move up or down.

I needed to connect a 1-1/2" sump pump drain pipe to a 4" DWV pipe for downspout waste water. (DWV pipe is sometimes referred to as SDR 35, and it's thinner than schedule 40 PVC). The sump pump drain pipe was at a weird angle and close to the foundation, and the slope of the DWV pipe was high where the connection was needed. 

I think the "correct" way to make this connection is to reduce the 4" to a 3", and use a stock 3" to 1-1/2" flush bushing.

I've had good luck using PETG for drain applications. Both PVC and PETG aren't rated for long term UV exposure. A coat of paint might make a PETG print last longer.

Tags