1 / 3
4 in. x 1-1/2 in. Spigot Hub Flush Bushing for PVC DWV — zdjęcie 1
1 / 3

4 in. x 1-1/2 in. Spigot Hub Flush Bushing for PVC DWV

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Bushing goes inside 4" DWV pipe, then 1-1/2" pipe is inserted into the bushing. Not glued.

Ocena
0 / 5
Polubienia
1
Pobrania
9
Wydruki
0
Wyświetlenia
65
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution

This bushing allows the insertion of the 1-1/2 pipe into the 4" pipe. The connection is intentionally not glued so that if the 4" in-ground pipe shifts or freezes, the drain waste pipe connection can move up or down.

I needed to connect a 1-1/2" sump pump drain pipe to a 4" DWV pipe for downspout waste water. (DWV pipe is sometimes referred to as SDR 35, and it's thinner than schedule 40 PVC). The sump pump drain pipe was at a weird angle and close to the foundation, and the slope of the DWV pipe was high where the connection was needed. 

I think the "correct" way to make this connection is to reduce the 4" to a 3", and use a stock 3" to 1-1/2" flush bushing.

I've had good luck using PETG for drain applications. Both PVC and PETG aren't rated for long term UV exposure. A coat of paint might make a PETG print last longer.

Tagi