1 / 5
Phone Bike Mount for M5 screws — image 1
1 / 5

Phone Bike Mount for M5 screws

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Phone Mount for M5 panhead and cylindrical Allen screws

Rating
0 / 5
Likes
1
Downloads
16
Makes
0
Views
117
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

The M5 makes the whole assembly a bit stiffer, don't overdo with the torque when mounting. Use the  shorter end of your Allen key for turning to limit torque. Perhaps use a bit of tyre tube as inlay in between the stem and the mount. With a bit of rubber even a low torque holds the mount very firmly, it is not possible to move it by hand.

All stls are included, also the FCStd. I only imported the original files and made the new cuts, so there is not a lot going on in the FreeCAD file. 

I printed the body and slider, which seem the most stressed parts, in Prusament PETG-CF (50% infill but infill modifiers with 100% in stressed regions), knob and bracket are printed in standard PETG (100% infill).  The bracket should give a bit of additional elasticity in PETG. Inserting a M5 washer spring first and then the M5 hex nut will give a little additional elasticity. Using an M5x20 bolt also leaves enough length for a counter nut. Use loctite on the nuts if you still are not sure. Use a second knob for countering slider and knob if you fear losing them riding without a mounted phone. 

Have fun,

emefff.

Tags