Philips Multigroom 5000 Series Trimmer & Accessory Organiser

My Philips 5000 Series Multigroom Trimmer came with a small bag for the accessories but annoyingly no stand. I got fed up with constantly misplacing attachments and accessories, so I made this remix to keep everything in one place.

There are a few empty slots by design. Those are for attachments I still haven’t found yet and to leave room for future expansion. I’ve also been considering 3D printing a few clip-style attachments, so I left myself with the option to expand later.

I’ve included a test piece for the stand (around 7g) so you can check fitment with your trimmer before committing to the full print. If you only want the stand itself you can increase walls and infill or use the original model this remix is based on. Use 1 wall with lightning infill to save filament.

PETG is recommended for its heat and moisture resistance but PLA will be fine if left in a drawer or on a desk

Print Settings Used

• 0.2mm layer height

• Variable layer height

• 10% gyroid infill

• 3 walls

• No supports required