HPI Racing Mini King Flux Ford Bronco - BATTERY COMPARTMENT & STEERING LINK
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
HPI Racing Mini Kahuna Monster Truck - BATTERY COMPARTMENT - for larger size Lipo batteries - ALSO - steering link
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 9
- Makes
- 0
- Views
- 116
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
The original HPI Racing mini kahuna monster truck battery (Plazma 7.4v 800mah 2S 35c Lipo) is very small (48.5x24.5x19mm) and the battery compartment is tight around that HPI battery so its impossible to use any other small Lipo in that compartment, so I have designed a simple lipo battery compartment that will fit underneath the body at the rear allowing a larger 'small' size lipo battery like the Ace Power 7.4v 850mAh 30C 2S LiPo Soft Case ACE850SC302SJST to be inserted up to a size of 68x31x14mm
No Supports Needed
Remove the two screws securing the driver to the hood - as shown
Remove the fuel tank screw - as shown (no longer needed, secure away somewhere)
Remove the original battery compartment locking lever screw (6mm in length) as shown.
Insert Lipo battery compartment and secure both screws back through the holes, holding the driver and new battery compartment in place
Secure back down the locking lever screw through the original hole attaching the new battery compartment and lever, best practice is to use another screw at 8mm if you have one available.
Flip the receiver 90deg anticlockwise - as shown, this will allow clearance with connectors underneath the battery holder, just pull it off double sided tape and stick back down.
Cut some 5mm velcro strap through the two side loops to secure the larger Lipo battery in place.
Done.
27/03/2026Added steering link, also know as part HPI-161127
