Agarose gel tray
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple 7x7 cm model for casting agarose gels. It also has a file for a basic comb.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 20
- Makes
- 0
- Views
- 120
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Public Domain
A very simple model for casting agarose gels. It'll get the job done, but will not hold up in a court of law. It's mostly relevant to hobbyists or teachers with a limited budget.
Printed in PETG. I have not tried it in PLA, but would worry about it holding up when pouring the gel.
The gel comes off without any fancy settings.
NOTE: I did find it easier to remove the gel by using the "ironing" function. If you use that function, make sure you choose "All top surfaces" (This will give a smoother surface to remove the gel, but will increase the print time significantly) instead of "Topmost surfaces only" (I found out the hard way that this is a waste of time for this model. When I think about what "topmost" means I have no one to blame but myself :)