Yokai 3.5 Orbiter 2.5 crossbow integration by ClutchKick512
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed the Yokai 3.5 orbiter setup to use the popular CrossBow cnc cutter.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 17
- Makes
- 0
- Views
- 338
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
RetroD's Yokai 3.5 Toolhead has a great cutter solution, for the apus 2 and nebula. I found with the orbiter 2.5 there were challenges. The trigger needed to be massively adjusted and I just could not get relaible cutting the way I wanted it. I had a fystec cnc crossbow cuter on hand and set out to make a remix so I could use it. This is the result of that work.
The main changes from the original mounting for yokai is that I split the orbiter mount, you will be making a "sandwich" around the cnc crossbow. The upper mount is setup identical to the original orbiter mount the 2 heat inserts go in the front most holes from the top.

The new "lower" mount has a place for 2 additional heat inserts in the top, these will be where your screws come down throught the orbiter-top mount-crossbow adapter-crossbow and then into the heat inserts.

I found the m3x20 bhcs worked well for me. you then will need m3x25 bhcs ( fit for me you may need shorter or longer) to install the screws from the bottom of the lower mount just like the normal yokai mounting system. at this point I have not tried to make the rear locking hole work but I am including the step file if you would like to make adjustments for it to be used, though with 4 screws already holding it I do not think it is needed.
I found that the original depressor arm and base from the DW-Tas crossbow github worked well - with the arm flipped upside down. Again I run titanium backers etc so you may need to make your own adjustments for the depressor.
When you are done you should have a Yokai 3.5 that looks like this, pat yourself on the back the easy part is over now get to tuning your macros!

Now once you have everything mounted I suggest you do some test feeds of the filament. On mine I needed to shorten the standard blade by .5mm as it was just barely shaving the edge of the filament as it passed through. It may be my mount or print I do not know but you will need to be sure to check for this.
here is the link to the stl page of that github.
https://github.com/DW-Tas/Crossbow-Filament-Cutter/tree/main/STL
RetroD has gifted the voron world with a truly awesome toolhead, I was actually a beta tester for the yokai 3.5 and this integration of the crossbow cnc is just my little way of trying to give back to the community with a mod that I wanted myself.
I have tested this with the rapido 2 uhf configuration, it should work just fine with the mako/bambu setup as well but I have not verified that yet.
