1 / 1
Yokai 3.5 Orbiter 2.5 crossbow integration by ClutchKick512 — zdjęcie 1

Yokai 3.5 Orbiter 2.5 crossbow integration by ClutchKick512

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remixed the Yokai 3.5 orbiter setup to use the popular CrossBow cnc cutter.

Ocena
0 / 5
Polubienia
6
Pobrania
16
Wydruki
0
Wyświetlenia
326
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

RetroD's  Yokai 3.5 Toolhead has a great cutter solution, for the apus 2 and nebula. I found with the orbiter 2.5 there were challenges. The trigger needed to be massively adjusted and I just could not get relaible cutting the way I wanted it. I had a fystec cnc crossbow cuter on hand and set out to make a remix so I could use it. This is the result of that work. 

The main changes from the original mounting for yokai is that I split the orbiter mount, you will be making a "sandwich" around the cnc crossbow. The upper mount is setup identical to the original orbiter mount the 2 heat inserts go in the front most holes from the top.

The new "lower" mount has a place for 2 additional heat inserts in the top, these will be where your screws come down throught the orbiter-top mount-crossbow adapter-crossbow and then into the heat inserts.

I found the m3x20 bhcs worked well for me. you then will need m3x25 bhcs ( fit for me you may need shorter or longer) to install the screws from the bottom of the lower mount just like the normal yokai mounting system. at this point I have not tried to make the rear locking hole work but I am including the step file if you would like to make adjustments for it to be used, though with 4 screws already holding it I do not think it is needed.

I found that the original depressor arm and base from the DW-Tas crossbow github worked well - with the arm flipped upside down. Again I run titanium backers etc so you may need to make your own adjustments for the depressor. 

When you are done you should have a Yokai 3.5 that looks like this, pat yourself on the back the easy part is over now get to tuning your macros!

Now once you have everything mounted I suggest you do some test feeds of the filament. On mine I needed to shorten the standard blade by .5mm as it was just barely shaving the edge of the filament as it passed through. It may be my mount or print I do not know but you will need to be sure to check for this.

here is the link to the stl page of that github.

https://github.com/DW-Tas/Crossbow-Filament-Cutter/tree/main/STL

RetroD has gifted the voron world with a truly awesome toolhead, I was actually a beta tester for the yokai 3.5 and this integration of the crossbow cnc is just my little way of trying to give back to the community with a mod that I wanted myself. 

I have tested this with the rapido 2 uhf configuration, it should work just fine with the mako/bambu setup as well but I have not verified that yet.

Tagi