1 / 3
Sovol SV08 Max 150mm ZZ Tophat - BTT 7 inch HDMI 1.2 — image 1
1 / 3

Sovol SV08 Max 150mm ZZ Tophat - BTT 7 inch HDMI 1.2

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Sovol SV08 Max 150mm ZZ Tophat replacement corner that adds the holder for the BTT 7 Inch ver 1.2 screen.

Rating
0 / 5
Likes
8
Downloads
81
Makes
1
Views
529
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

This is an addon to the Sovol SV08 Max 150mm ZZ Tophat 


The addon is a replacement corner that adds the holder for the BTT 7 Inch ver 1.2 screen.

This model uses 8x4mm inserts for the fans all other holes do not and are just printed slightly smaller to allow threded screws to fit nicely.

A great care was made to be able to print without much support, so hopefully "Automatic support" would be good to go, at least maybe with my setting below.   Note there a a small tab on each side when you slide in the glass that you break off after printing, this limits the need of support greatly. This was testing by printing with 0.4 nozzle and 0.4 linewith. If you use 0.6 you might need to set Wall generator - Arachne 

I print this with Ocra slicer using:

Quality

  • Wall generator

    • Wall generator - Arachne 

Support tab

  • Enabling support,

    •  "Tree (auto)" 

    •  Threshold angle: 20 dgr

    •  Remove small overhang

  • Advanced

    • Top Z distace 0.34  (for more easy removal, you might want to test/tune this)

    • Bottom distace 0.34  (for more easy removal, you might want to test/tune this)

With this I printed the 4 big corners as then normaly stand and Ocra only adds support for the first few mm to the first edge and some support for the glas holder slider cut ins.

Notable other setting is that in Quality tab I use Bridge flow rate:  1.75 and my filement setting has 100% fan on "Overhangs and external bridges fan speed" this is to make overhang/bridges more nice, not sure if it strictly needed for this print.

Warning: This is a large print and made to be printed on the SV08 Max itself to keep number of pieces down.  E.g. some part probably need an print area of about 360x360 and even lager for the IKEA Förnuftig addond e.g 470x360

Link to CAD files:
https://cad.onshape.com/documents/017be025acd33fb5c4a610f1/w/99d8c6f61eba4f77f98a66d0/e/680cb076dd87bd3e6a5822c2?renderMode=0&uiState=69622db234b872f316faa131

Version history:
V22 2026-01-24 First version 
V29 2026-03-02 Add 0.3mm space around top glass and add breakoff support so less support is needed,. Thanks Doug Walkerfor the suggestion.

Tags