1 / 1
IKEA Pax wall anchor spacer / podložka pro uchycení do stěny — image 1

IKEA Pax wall anchor spacer / podložka pro uchycení do stěny

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Spacer to put between the wall and the wardrobe anchoring point to secure it. Podložka mezi zeď a kotevní bod skříně.

Rating
0 / 5
Likes
1
Downloads
8
Makes
0
Views
53
Reviews
0

Updated at source:

Model information

Category
Bedroom
License
Creative Commons — Public Domain

The IKEA Pax wardrobe has an upper anchoring point for screwing it to the wall. However, if you don't put the wardrobe tight to the wall, you will get a space between the wardrobe and the wall. This makes screwing it properly without having the screws pull the anchoring point to the back tricky. So you can print this spacer, put it in between the wall and the wardrobe and put the screw through it.

Adjust (scale) the height of the model in the slicer according to your needs (mine is 23mm). I put the wider side on the wall. The screw hole is 5mm, so it should be good for most screws.

My print settings: 0.25mm layer, 3 perimeters, 15 % infill, 0.4 nozzle.


Skříň IKEA Pax má horní kotvící body přes které se šroubuje do stěny. Pokud ale nemáte skříň přímo u stěny, vzniká mezera a hrozí, že si skříň nakloníte tím, že ji moc přitáhnete. Řešením je jednoduše vytisknout tuto podložku, dát ji mezi skříň a zeď a šroub protáhnout skrz podložku.

Upravte výšku podložky pomocí škálování ve sliceru podle prostoru za skříní (v modelu je výška 23mm). Širší část jsem dal na stěnu. Díra na šroub je 5mm, což by mělo stačit pro většinu šroubů.

Moje nastavení tisku: 0.25mm vrstva, 3 permetry, 15 % infill, 0.4 tryska.

Tags