Custom Magnet Connector
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a custom magnetconnector for "THE FILTER". No soldering needed (so far for me)!
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 56
- Makes
- 0
- Views
- 283
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a magnetic connector for ‘THE FILTER’ as a replacement for the POGO connector.
Parts list:
4x neodymium magnets 6x3
Superglue
The cables are stripped and then fed through the guides. The strands are spread slightly over the fittings for the magnets, then the magnets are pressed in.
The fittings have a diameter of 6 mm. Depending on the printer, you may play around with the ‘hole expansion’ so that the magnets can be pressed in, hold securely in the fitting and the cable strands do not slip out.
It is quite tedious to fiddle the cables through the guides, but it worked.
After printing my connectors, I made some small changes to the files, which have not yet been tested. However, it should be an improvement over my first version (which I printed).