1 / 3
Monster / Red Bull / Energy Drink Can Ice Bath Chiller — image 1
1 / 3

Monster / Red Bull / Energy Drink Can Ice Bath Chiller

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

If you like to enjoy your Monsters over the span of a few hours like I do, you need a way to keep them nice and cold.…

Rating
0 / 5
Likes
72
Downloads
241
Makes
0
Views
2,349
Reviews
0

Updated at source:

Model information

Category
Kitchen
License
Creative Commons — Attribution — Noncommercial

If you like to enjoy your Monsters over the span of a few hours like I do, you need a way to keep them nice and cold. What's colder than an ice bath? (Nothing you want to stick a can of Monster into, wise guy.)

This keeps the ice out of the middle so you can actually take the can out and put it back without all the ice getting in the way. You're not shy about a few drips of water, right?

Fits both sizes of Monster cans, so I'm sure it'll fit pretty much anything else. There's a conservative fill line inside so you don't overflow.

That's about it! Enjoy!

Print Settings

Printer:

Anycubic Linear Kossel XL

Rafts:

No

Supports:

No

Resolution:

.2

Infill:

25

Filament:

Hatchbox PLA

Any


Notes:

I used 3 perimeters and 6 top/bottom layers (1.2mm all around), plus ironing, and printed hot (210C) to try to make it watertight, but I'll probably end up spraying the inside with kind of sealant to be extra-sure.

If you want the two-tone effect I got, just run out of filament and replace with a spool of a different color partway through the print. Or, you know, just pause the print whenever and do it on purpose! The 70-72mm mark is a good time to do it.

How I Designed This

Designed from scratch in Sketchup.

Category: Kitchen & Dining

Tags