Creality K2 Pro Dedicated Poop Chute.

Attention: You will need 5x2 mm magnets. (8 pieces).

I couldn't find a decent design for the "Poop Chute" part.
But I liked the file with rounded shapes. https://makerworld.com/ru/models/2278606-creality-k2-pro-dedicated-poop-chute-super-materia ?from=search#profileId-2484621

But there was a lot of stuff in it, and I had to completely create a new file, but under the impression of the shapes I saw.
I also applied an excessive magnetic mount in my file, which guarantees a good fixation to the case. And there will be no rattling during intensive operation of the 3D printer.
Printing without supports.
There are also recesses in the part for the screw that is located on the printer.
The installation will not cause a conflict in the installation.
Use some superglue to fix the magnets.
The holes are precise, requiring good printer settings.
If the top of the hole was almost not accurate, process it with a tool.

Be sure to wait for the part/printing table to cool down before removing it.
This will guarantee a straight line and no distortion.

Please note that during installation, the part should stand as in my photo and not block the ventilation of the printer equipment.