HYPERFORMA_Floatwheel ADV-ADVPro Motor Cable Connector Adapter (ADV1 to ADV2)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
ADV2 "V3 Motor" Cable Adapter for ADV1 Front ESC Case
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 4
- Makes
- 1
- Views
- 45
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Share Alike
If you’re skilled enough to rewire the motor, this part lets you adapt the V3 motor harness to the ADV1 front case.
You must use it together with the original large nut from the ADV1 connector.
The threads are:
Inner: M18 × 1.5
Outer: M24 × 1.5
Make sure to print this part in a very strong material with good layer bonding and good resistance to water and moisture. PETG is usually strong enough if printed properly.
Because this part is hard to reach once installed, be sure to print it in the correct orientation for maximum strength.
To improve waterproofing, I recommend using a flowing silicone sealant around the connection. i've used Permatex 81730.