Over-Center Toggle for offset mounting
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Latch with offset design for door with heavy trim. 18x31.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 37
- Makes
- 0
- Views
- 275
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Garage
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Another take on the over-center latch I needed for a specific door in a conversion van. This door has a corner I needed to get around, so it's designed for that specific spacing. I can change that a little, so if this is close to what you need but not quite right, send me a message and I'll see what I can do =]
This version needs way less hardware and tucks into the corner (at least it did for my specific use case with heavy trim on the door frame.)
Print for strength, 3 walls, 6-8 tops and bottoms, dense or solid infills etc.
Just print 2 loop sides, and one of each of the rest. STLs should all be in ideal printing orientation. (supports required for base and handle. I usually try to design for support-free printing, but this design demanded strength over efficiency.)
The "loop" cross pieces may snap in tight enough not to need glue. I still glued mine even though they needed a few good hits to set them in tight, since it was going in a van and I didn't want it to rattle loose.