Arrma Granite 223s V4 Body Lift & Chassis Brace
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Strong Lightweight Crash Brace and 7mm Body Lift
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 24
- Makes
- 0
- Views
- 285
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a chassis brace for my arrma granite V4 which is very different than previous models when it comes to adding any existing 3d printed part or older accessory. I found nobody makes a V4 brace so I made one myself. In the process I decided to use the body post as the anchor point since doing so will raise the body up and away from the seriously aggressive tire rubbing. The tire rubbing is a glaring oversight of the arrma engineers, requiring quite a bit of the body needing to be trimmed. I don't mind trimming the body but it does take away from the look so the less I need to trim the better. So far I only get tire rub on the hardest of braking or landings, not enough for me to feel the need to trim the body yet. The brace is hollow and surprisingly strong considering how lightweight it all is. The brace will raise the body by 7mm. The clip-less body retention system is completely unaffected and works as it should and the original four body post screws are used so no additional items are needed. The body is lifted enough to increase air flow without letting in extra debris. I run in a combination of mud and dry leaves and I didn’t notice any significant difference in my normal collection of muck. There's also plenty of clearance for your battery of choice. The brace has supports built in so just put the flat spot on the brace on the plate and the same for the post mount and it's good to go no additional supports needed. You need two post mounts and the flat ends of the mounts go towards the electronics. You will need to drill pilot holes for the new screw location on the body post. I recommend at least petg or stronger material. You can see in the video I can use it as a handle. UPDATE: I ran into a cinder block wall while almost at top speed on 3s. I broke no factory part of the granite. The brace and nose guard combo did there job and took all the force of the impact. The nose guard, one body mount and the brace bar shattered. The body is unharmed. The bumpers and chassis also unharmed. The pictures show the damage to the support parts. Go and look at the hood protector damage. That is an integral part of the overall system and performed flawlessly. UPDATE April 2026: I've added a slightly thickened version. The mount in V2 is 7.5mm thick and the brace bar is now 1.5mm thick. I found a dip in my yard that I can get huge air on and the brace bar was cracking from hard skid plate and nose landings. The added thickness only aids in its flexibility under those types of circumstances. It still shatters like it should on impact.