1 / 3
Home Assistant ZWA-2 and ZBT-2 upside-down wall mounts — image 1
1 / 3

Home Assistant ZWA-2 and ZBT-2 upside-down wall mounts

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

For an unorthodox but sometimes convenient upside-down wall mounting of either of these antennas.

Rating
5 / 5
Likes
8
Downloads
112
Makes
2
Views
554
Reviews
2

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

Antenna mount for the nice ZWA-2 Z-Wave and ZBT-2 Zigbee/Thread adapters from Home Assistant.

My server room is the cubby under the stairs, so when getting these nice new antennas, I needed to find a place to mount them as much out of the way as possible. The solution was to hang them upside-down from the stairs.

It can of course be used in any wall-mounting scenario - they hang more securely than if just standing on a shelf, especially if they are in a place where they could be knocked over.

The ZBT-2 model is the same as the ZWA-2 model just without the extra distance between wall mounting plate and the "antenna hole", to account for the smaller base.

I assume that the antenna lobes are approximately the same upward and downward from the horizontal plane, so upside-down mounting shouldn't be an issue for radio coverage. The ZWA-2 does complain if it's placed sideways (accelerometer I assume) but not if upside-down so I take that as rock-solid confirmation.

Yes, my ZWA-2 print came out quite ugly, I went for quite aggressive Prusa slicer standard settings of 2 perimeters and 4 top layers along with 5% gyroid infill as well as less than perfectly dry PETG. If you want a nicely smooth inside (that you'll never see once mounted), then bump up number of top layers and/or use more infill or more top-level supportive infill pattern. Oh yes, and the print in the photos was before I did the final tweaks to chamfer the screw holes and fillet the top of the mounting plate.

Tags