1 / 3
Home Assistant ZWA-2 and ZBT-2 upside-down wall mounts — zdjęcie 1
1 / 3

Home Assistant ZWA-2 and ZBT-2 upside-down wall mounts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

For an unorthodox but sometimes convenient upside-down wall mounting of either of these antennas.

Ocena
5 / 5
Polubienia
8
Pobrania
112
Wydruki
2
Wyświetlenia
554
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Antenna mount for the nice ZWA-2 Z-Wave and ZBT-2 Zigbee/Thread adapters from Home Assistant.

My server room is the cubby under the stairs, so when getting these nice new antennas, I needed to find a place to mount them as much out of the way as possible. The solution was to hang them upside-down from the stairs.

It can of course be used in any wall-mounting scenario - they hang more securely than if just standing on a shelf, especially if they are in a place where they could be knocked over.

The ZBT-2 model is the same as the ZWA-2 model just without the extra distance between wall mounting plate and the "antenna hole", to account for the smaller base.

I assume that the antenna lobes are approximately the same upward and downward from the horizontal plane, so upside-down mounting shouldn't be an issue for radio coverage. The ZWA-2 does complain if it's placed sideways (accelerometer I assume) but not if upside-down so I take that as rock-solid confirmation.

Yes, my ZWA-2 print came out quite ugly, I went for quite aggressive Prusa slicer standard settings of 2 perimeters and 4 top layers along with 5% gyroid infill as well as less than perfectly dry PETG. If you want a nicely smooth inside (that you'll never see once mounted), then bump up number of top layers and/or use more infill or more top-level supportive infill pattern. Oh yes, and the print in the photos was before I did the final tweaks to chamfer the screw holes and fillet the top of the mounting plate.

Tagi