Würth Ledlenser P7 Rebuild/Upgrade
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I own an older Ledlenser (sold at Würth 2016-2018), old LED is so weak it needed an upgrade.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 3
- Makes
- 0
- Views
- 74
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
The files consist of an adaptor for a Convoy 1288 switch, an adaptor for a 16mm LED and finally a slieve for a 18500 LiIon cell.
With those parts I was able to put a 10W Cree LED in the good old LEDlenser body.
Don't forget to order some high-temp Silicon-Glue, it necessary to glue the LED-PCB to the brass piece. I had to learn it the hard way by resoldering the + wire to the LED-PCB a few times ;-)
If your build it check the pictures for the extra wires, those are necessary to connect the neg to the Aluminium body. As the Aluminium is anodized it's not conducting and I needed to sand it of at some spots...