Xol Toolhead Eddy Mount (HF) +2mm and +3mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Additional mounting lengths for Eddie on the Xol toolhead (HF, not UHF).
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 22
- Makes
- 0
- Views
- 96
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I created these, because I have nozzles with slightly different lengths that I want to run on my Xol toolhead (CHT, Mk8, etc.), and Eddy has a limited range available, in relation to the nozzle. These move Eddy closer to the bed, for a nozzle longer than the standard from the Xol design (V6 nozzle, in my case, for the Rapido HF).
The design is loosely based on the original, but I opened up the dimensions for the eddy slightly, as the original is far too tight. It's now properly tight, and an access hole is added for the boot button.
I printed these with some leftover ABS that had been sitting out, to finish off a spool. If I eventually switch back to using the UHF, I might eventually make those variants, as well.
See the toolhead docs for recommended print settings.