Xol Toolhead Eddy Mount (HF) +2mm and +3mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Additional mounting lengths for Eddie on the Xol toolhead (HF, not UHF).
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 96
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I created these, because I have nozzles with slightly different lengths that I want to run on my Xol toolhead (CHT, Mk8, etc.), and Eddy has a limited range available, in relation to the nozzle. These move Eddy closer to the bed, for a nozzle longer than the standard from the Xol design (V6 nozzle, in my case, for the Rapido HF).
The design is loosely based on the original, but I opened up the dimensions for the eddy slightly, as the original is far too tight. It's now properly tight, and an access hole is added for the boot button.
I printed these with some leftover ABS that had been sitting out, to finish off a spool. If I eventually switch back to using the UHF, I might eventually make those variants, as well.
See the toolhead docs for recommended print settings.