T-15 mini disc shooter remodel

I cosmetically altered the original to my liking: https://makerworld.com/en/models/497751-t-15-tec-9-disc-shooter#profileId-481950

Please like and upload makes.

Assembly takes 5 mins.

Hardware: 3 rubber bands, M3X20-50 screw

Features a  real picattiny rail, so… mount your own sights.

Two magazine sizes:  a full size and a 10-round.

Print settings: 3 walls, 15-20% infill, print as oriented, tree supports, only parts that must be in PETG are trigger and mag spring (if you decide to use it insted of rubber bands).

Assembly guide:

1. Take a barrel insert, an upper receiver, a knob, M3 screw, rubber bands, a piece of filament and a slide.

Put a rubber band (or two) in a barrel insert cutout, then push a piece of filament through to licn it in place, snap excess.

Insert a barrel into the upper receiver.

With a hook fish the rubber band through the slide and secure it on the back.

Insert a slide into the upper receiver, thread a screw through a knob and thread it into the slide.

1. Take a lower receiver, a trigger, back stop, and a piece of filament.

Grease a rail on the lower receiver or a rail on the trigger, then insert it. Insert a stop behind it. 

Mount the top receiver assembly by wiggling the slide into the top rail of the trigger, then the rear protrusion of the upper receiver should get into the rail where trigger is. Snap a front part of the receiver dwin on the lower receiver and slide it back so the front protrusion snaps into place of the socket on the lower receiver.

Secure receivers and a back stop with a piece of filament.

3.1 Add a trigger sleeve

1. Add a picattiny rail. Slide it on and secure with a piece of filament.

1. Magazine assembly. Take magazine cap, follower, the body and a rubber band.

Thread a band through the center of the follower down, then thread it through the finger grip, insert it in the magazine body and secure on top of the body.

1. Print discs and have fun!