Self-Draining Sponge Holder V2 | Wave Drip Tray
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
V2 of my popular sponge holder! Now features taller wave ribs and a steeper slope for faster, better water drainage.
- Rating
- 4.905 / 5
- Likes
- 702
- Downloads
- 4,064
- Makes
- 22
- Views
- 9,370
- Reviews
- 21
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
BOM: Printed with ROSA3D Starter PLA Black
Say goodbye to soggy, smelly sponges. This upgraded drip tray features a functional wave pattern that lifts your sponge (or soap bar) up, allowing air to circulate underneath and water to flow away freely.
🚀 What's New in V2?
Steeper Drainage Angle: The bottom slope is slightly increased, ensuring water flows down into the sink much faster without pooling.
Taller Wave Ribs: The ridges are now higher, which means even soaking wet sponges are kept well above the water line for maximum airflow and faster drying.
Key Design Feature: The front of the holder has a dedicated drainage spout/opening. Position this edge over your sink, and excess water will naturally drain out, keeping your countertop dry and your sponge hygienic.
The Set Includes 2 Sizes:
Standard (95x65mm): Perfect for standard kitchen sponges. Fits items up to ~95x65mm comfortably.
Large (115x85mm): Great for larger scouring pads or big bars of artisanal soap. Fits items up to ~115x85mm.
Printing Instructions:
Material: PETG or ASA are recommended because they handle moisture and cleaning chemicals better than PLA (though PLA works fine for a while).
Supports: None required.
Infill: 15-20%.
Watertight: Ensure your "Flow" is calibrated or increase wall count to 3-4 to ensure the tray doesn't leak.