Self-Draining Sponge Holder V2 | Wave Drip Tray
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
V2 of my popular sponge holder! Now features taller wave ribs and a steeper slope for faster, better water drainage.
- Ocena
- 4,905 / 5
- Polubienia
- 698
- Pobrania
- 4042
- Wydruki
- 22
- Wyświetlenia
- 9329
- Oceny
- 21
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
BOM: Printed with ROSA3D Starter PLA Black
Say goodbye to soggy, smelly sponges. This upgraded drip tray features a functional wave pattern that lifts your sponge (or soap bar) up, allowing air to circulate underneath and water to flow away freely.
🚀 What's New in V2?
Steeper Drainage Angle: The bottom slope is slightly increased, ensuring water flows down into the sink much faster without pooling.
Taller Wave Ribs: The ridges are now higher, which means even soaking wet sponges are kept well above the water line for maximum airflow and faster drying.
Key Design Feature: The front of the holder has a dedicated drainage spout/opening. Position this edge over your sink, and excess water will naturally drain out, keeping your countertop dry and your sponge hygienic.
The Set Includes 2 Sizes:
Standard (95x65mm): Perfect for standard kitchen sponges. Fits items up to ~95x65mm comfortably.
Large (115x85mm): Great for larger scouring pads or big bars of artisanal soap. Fits items up to ~115x85mm.
Printing Instructions:
Material: PETG or ASA are recommended because they handle moisture and cleaning chemicals better than PLA (though PLA works fine for a while).
Supports: None required.
Infill: 15-20%.
Watertight: Ensure your "Flow" is calibrated or increase wall count to 3-4 to ensure the tray doesn't leak.