BTT M8P V2.0 Mount for K1/K1C
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This mount lets you fit a M8P v2.0 inside a creality k1/k1c
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 26
- Makes
- 0
- Views
- 217
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution
This mount was designed for the K1/K1C with one major feature in mind.
No needing to dremel your printer, this mount has the bottom fins of your printer cut out to avoid you having to grind them away. It mounts with the original screws that holds the stock mcu in place.
BOM:
8x voron heat inserts m3x5x4
4x m3x8 or m3x20
4x m3x25
Arctic P12 fan 12v
make sure you use 12v jumpers on your board when using the Arctic P12!
INSTALLATION:
Insert heat inserts in both printed parts as below
Screw Arctic fan to the shroud using either m3x8 or m3x20 screws.
the reason you have 2 options is cable management.
m3x8: just holds the fan to the shroud.
M3x20: holds the cable behind the screw
Screw mount to your printer.
When done wiring, you can use m3x25 screws to bolt the fanshroud into the mount (screw goes through M8P v2.0 holes and holds the board in place)
PRINTING:
No supports needed, shroud holes are optimized with partial bridging to print smooth.
mount bridging is minimal, no supports needed. print everything with your desired settings.
mine was printed in Black ASA filament