1 / 3
Wii Sensor Bar Mount for TCL 43Q51K TV — image 1
1 / 3

Wii Sensor Bar Mount for TCL 43Q51K TV

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A replacement, none adhesive sensor bar holder for your TCL 43Q51K TV. Clips onto the Sensor Bar and sits on TV.

Rating
0 / 5
Likes
2
Downloads
15
Makes
0
Views
94
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

Hello! This is a simple mount for the Wii Sensor Bar from Nintendo. It is designed to clip onto the sensor bar and sit on top of your TV with minimal tilt. Due to angular design of the TCL TV back, this will have a very slight sag (~5 degrees) but looks clean and does the job.

Information

I printed mine on my K1C 3D printer, so your print may require different settings.

Print Settings

In my case, this print was done on its side, with 0% infill, at 0.08mm layer height. The one without the logo can be done at a thicker layer if you want. I recommend adding a Normal, Snug support set to build plate only, so the alignment circle is printed correctly. You may need to file down the supported side for better fitting.

Usage

Installation steps are extremely easy. Line the dot up with the circular hole on the bottom of the Sensor Bar, then push the back side upward to snap it into place. Then center it on the TV, the front lip shouldn't touch the screen, and it has been rounded to prevent damage.

To remove it, just push on the front lip (or where the Wii logo is), to unclip it.


Thank you for trying out my model! If you liked it, be sure to leave a like!

Tags