Headset Stand with Clamp for Desks
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple yet elegant headset stand for countertops equal or smaller than 40mm in thickness.
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 106
- Makes
- 1
- Views
- 288
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Share Alike
This is a headset stand that clamps onto your desk. I have not printed the model, as I do not have a 3d printer yet, but if you do decide to print this model, please rate it and upload a photo of the model. Any feedback is highly appreciated!
Recommended print settings:
-30% gyroid infill (minimum recommended)
-3 wall loops (minimum recommended)
Print the stand on it's side, you could add a 4mm brim for maximum security
-ORIENTATION MATTERS!!! The teardrop hole must be pointing UP!
.2mm layer height should be fine, the lower the better though.
! Depending on the printer calibration, the screw may be harder to screw into the clamp for the first time, so you may have a difficult time using it right after printing.