Headset Stand with Clamp for Desks
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple yet elegant headset stand for countertops equal or smaller than 40mm in thickness.
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 105
- Wydruki
- 1
- Wyświetlenia
- 283
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Share Alike
This is a headset stand that clamps onto your desk. I have not printed the model, as I do not have a 3d printer yet, but if you do decide to print this model, please rate it and upload a photo of the model. Any feedback is highly appreciated!
Recommended print settings:
-30% gyroid infill (minimum recommended)
-3 wall loops (minimum recommended)
Print the stand on it's side, you could add a 4mm brim for maximum security
-ORIENTATION MATTERS!!! The teardrop hole must be pointing UP!
.2mm layer height should be fine, the lower the better though.
! Depending on the printer calibration, the screw may be harder to screw into the clamp for the first time, so you may have a difficult time using it right after printing.