1 / 2
Formula 4 Steering Wheel Grip Moulds and Mould Stand — image 1
1 / 2

Formula 4 Steering Wheel Grip Moulds and Mould Stand

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Moulds and a Mould stand for the SimbaSim F4 Steering Wheel.

Rating
0 / 5
Likes
1
Downloads
19
Makes
1
Views
226
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial — Share Alike

Moulds and Moulding stand for the SimbaSim F4 Steering Wheel 

Contains the 4 moulds (two for each grip) and a moulding stand. You'll need to attach the stand to the wheel plate with a M5 25mm bold and nut.

Moulding Grips with Polyurathane Resin

I use the 'Polytek Poly PT Flex 60 Liquid Casting Rubber' which is available here: https://www.mbfg.co.uk/pt-flex-60-rubber.html - you will also need the black dye (which is available here: https://www.mbfg.co.uk/polytek_pigment.html). This has a pot life of around 4 mimutes, so make sure you have everything prepared before you mix up the rubber.

You will need:

  • Water washable resin

  • Cornflour

  • Sanding paper from 180 to 1000 (sanding sponges are ideal for this - https://alishort.com/CUJ6 )

  • Hot glue gun

  • Spring Clamps

  • 2x 500ml plastic measuring jugs for part A and Part B

  • 300my syringe

  • 2ml syringe for the dye

  • Weighing scales

  • Rubber mallet

  • Demoulding wedge or car trim removal tools

  • Silicone spatula for mixing

  • Scalpel

  • Side cutters

  • Kitchen Paper

  • Mould release silicone spray

How To Cast Rubber Grips tutorial

Prepare the Moulds

  • Print off with 4 walls, 15% infill

  • To fill in the layer lines, use a mix of water washable resin and cornflower (mixed 1:1, just paint it on and put on a window ledge to cure in the sunlight)

  • Sand up to about 400 grit

  • Apply high build primer and sand to around 1000

  • Sand the mating faces flat to about 1000

Prep for moulding with Polyurethane rubber

  • Spray with mould release silicone and allow to dry

  • Mount onto the plate and stand upside down (the moulds fill from the bottom) and ensure the front moulds are on the countersunk side of the plate

  • Use spring clamps to hold them moulds on, and make sure they are aligned correctly

  • Use a hot glue gun to seal the edges of the mould

Mixing and injecting rubber (for one grip)

  • Pour out 200g of mixing rubber (100g of part A in one container, 100g of part b in another container)

  • Add 2ml of black dye to part B and mix (check the instruction for whichever dye you buy - different colour require different ratios)

  • Add part A to part B and mix for no longer than 30 seconds. Mix at a steady pace, if you over mix the pot time will reduce

  • Draw the rubber into a 300ml size syringe

  • Wipe the nozzle of the syringe

  • Inject steadily into the mould

  • Allow it to set

  • Use demoulding wedges or car trim removal tools (you can 3D print these) and a rubber mallet to remove the moulds

  • Trim the flash off of the grips with a scalpel and side cutters

Tags