GHT-F 3/4 to NPT-F 1/4 Adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adapter to connect a pressure gauge or any NPT 1/4 air fitting to an standard 3/4 garden faucet.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 35
- Makes
- 0
- Views
- 125
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
This is inspired on this design by @bababuii:
https://makerworld.com/en/models/54218-3-4-ght-garden-hose-thread-to-1-4-npt-air-fitting#profileId-55929
But I have a problem with the 3/4 thread on that model, it was too tight and it have a tendency to cross thread, specially the first time you connect it. So I made my own, using a more accurate GHT 3/4" model.
Printing settings (That I use, not necessary the best):
- Material: Generic PETG
- Nozzle: 0.4mm
- Temp: I printed 10ºC higher than my usual prints, at the top limit on the manufacturers range for this filament (250ºC on my case).
- Layer Heigh: 0.2 mm
- Infill: Gyroid at 50%
- Wall loops: 10
- Orientation: The 1/4" thread facing down on the plate.
- Not Supports.
- I added a modifier to iron just the base of the 3/4" thread, so a gasket seats better, i dont think this is that important.
Disclaimer:
This model is provided as‑is with no pressure rating. Use at your own risk. I’m not responsible for damage or injury resulting from its use. In my own tests at ~80 PSI for long periods, it has held without leaks, but results may vary depending on material, print quality, and application.
