1 / 3
GHT-F 3/4 to NPT-F 1/4 Adapter — zdjęcie 1
1 / 3

GHT-F 3/4 to NPT-F 1/4 Adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adapter to connect a pressure gauge or any NPT 1/4 air fitting to an standard 3/4 garden faucet.

Ocena
0 / 5
Polubienia
5
Pobrania
33
Wydruki
0
Wyświetlenia
119
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution

This is inspired on this design by @bababuii:
https://makerworld.com/en/models/54218-3-4-ght-garden-hose-thread-to-1-4-npt-air-fitting#profileId-55929

But I have a problem with the 3/4 thread on that model, it was too tight and it have a tendency to cross thread, specially the first time you connect it. So I made my own, using a more accurate GHT 3/4" model.

Printing settings (That I use, not necessary the best):

- Material: Generic PETG
- Nozzle: 0.4mm
- Temp: I printed 10ºC higher than my usual prints, at the top limit on the manufacturers range for this filament (250ºC on my case).
- Layer Heigh: 0.2 mm
- Infill: Gyroid at 50%
- Wall loops: 10
- Orientation: The 1/4" thread facing down on the plate.
- Not Supports.
- I added a modifier to iron just the base of the 3/4" thread, so a gasket seats better, i dont think this is that important.



Disclaimer:

This model is provided as‑is with no pressure rating. Use at your own risk. I’m not responsible for damage or injury resulting from its use. In my own tests at ~80 PSI for long periods and short test of up to 174 PSI (That is the limit of my pressure gauge, so it is likely more than that), it has held without leaks, but results may vary depending on material, print quality, and application.

Tagi