1 / 4
ADT-Link UT3G eGPU-Case - ATX PSU, 280mm 2.5 slot GPU — image 1
1 / 4

ADT-Link UT3G eGPU-Case - ATX PSU, 280mm 2.5 slot GPU

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

eGPU-Case for desktop GPUs and a regular ATX PSU.

Rating
0 / 5
Likes
3
Downloads
43
Makes
0
Views
786
Reviews
0

Updated at source:

Model information

Category
Computers
License
GNU General Public License v3.0

This is an eGPU base based on the ADT-Link UT3G eGPU board, allowing you to connect a desktop GPU to any device with a USB4 or Thunderbolt connection. Useful for 3D scanning with smaller laptops, video games and whatnot and makes the entire assembly less finicky. 

Disregard print quality, I should have printed slower. I recommend PETG. 

BOM: 
10x 8mm SHCS M4 bolt
8x M4 hex nut
ADT-Link UT3G
4x #6-32 UNC 10mm screws 
160mm max length ATX PSU ( modular recommended)
GPU that is at most 280mm long, 58mm thick ( roughly 2.5 slots) and 127mm wide - width can be bigger if you have some form of 90° adapter for the PCI-E power connectors. 
I built this for an Asus RTX 2080 Dual OC. A Titan V also fits. 

If you have a longer GPU, you can cut apart the middle part and add more length. If you have a thicc GPU, you're out of luck. 

Assembly: Print all parts once, supports are only needed for the lid and the middle case if you orient them correctly. 

Slide the PSU in to its case from the middle, then push it to the side so it can be bolted down with the #6-32 UNC screws. Attach all necessary cables to the PSU. 

Bolt GPU end, PSU end and middle section together using M4 SHCS screws and nuts. The screw heads go on the outside.Make sure the PSU fan and the GPU fans point in the same direction. 

Plug the UT3G board in to the PSU. Mount the UT3G-Board with the screws and nuts that it's feet came with. Mount only the board, not the spacer it usually sits on. 

Mount the GPU on the UT3G. Bolt it down with 2x SHCS bolts. The bolts get threaded into plastic. 

Plug the PSU cables in to the GPU. 

Put the lid on, then slide it towards the PSU end until you can push the bolt through the GPU end, securing the lid. 
You can now secure the bolt, if necessary, with the clip. 

On the opporite side of the fan side, you will see a larger opening in a series of small holes. You can push your USB4/Thunderbolt cable through this opening in to the UT3G-board. 

I recommend PETG. 

Tags