ELEGOO Centauri Carbon Side Protector - Celtic Knot Heart Circle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A protector to keep the filament spool from wearing the finish off the side of an ELEGOO Centauri Carbon (CC1).
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 18
- Makes
- 0
- Views
- 128
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A Celtic knot heart circle used to protect the side of an ELEGOO Centauri Carbon (CC1) from wear caused by the filament spool unwinding.
A hole is provided for the spool holder and is held in place using the OEM screw located below and to the left of the spool shaft (see photo). While the model is suited to be printed in a single color, I manually entered an M600 filament change command in the slicer to produce the two (2) color 3D print. The specified point to change the filament in your print, if desired, will vary depending on your slicer settings.
NOTE: The print is large (247.32 mm diameter x 3 mm height) and with the specified slicer settings it took approximately 2.75 hours from start to finish.