Prusa Advanced Filtration to Nispira 3-in-1 HEPA Carbon Filter Adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adapter to allow the use of Nispira 3-in-1 HEPA Carbon filters in the stock Prusa Advanced Filtration housing.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 6
- Makes
- 0
- Views
- 95
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
I added the Prusa Advanced filtration module on to my core one but I was disappointed to see the cost of the filters after shipping to the USA, and the general lack of availability.
I found these Nispira 3-in-1 HEPA Carbon filters (https://amzn.to/4s1hZXh), which actually look just like the Prusa units but are just a little smaller. In the USA I could buy at least five of these for each Prusa filter once I factor in shipping / etc.
Since the filters are a little smaller, they require an adapter to fit into the Prusa Advanced filtration housing. That's what this is :)
Print this adapter, and add your favorite low density foam tape around the outside (I used https://amzn.to/4qOQ5Nc), slide the filter into the inside, and push it into the standard advanced filtration housing. Easy as that.
I printed this on the core one out of Overture PETG filament using the Prusament PETG profile on the 0.25mm SPEED profile - fits like a glove.
Enjoy.